Replacing the Transfer Case Driven Gear Bearing (Honda HR-V 1)

Note: Apply transmission fluid to all parts during assembly.

1. Using a special tool, press out the tapered roller bearing from the transfer case driven gear shaft.

1. TRANSFER CASE DRIVE GEAR SHAFT
2. PRESS
3. WASHER
4. TAPERED ROLLER BEARING
5. BEARING SEPARATOR (available for sale)

2. Install a 35mm thrust shim onto the transfer case driven gear shaft.

3. Using the special tool, press a new tapered roller bearing onto the transfer case driven gear shaft as shown in the figure.

1. PRESS
2. MANDREL HANDLE, inner diameter 40 mm, 07746-0030100
3. MANDEL, int. diameter 35 mm, Q7746-0030400
4. TRANSFER CASE DRIVE GEAR SHAFT
5. TAPERED ROLLER BEARING

The text was taken from the website hondabook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Automatic gearbox

Next ▶

Replacing the transfer case drive gear bearing
Transfer case — design description
Control shaft assembly — removal and installation
Ring gear bearing — replacement
Flywheel housing bearings — replacement

Replacing the roller bearing of the transfer case housing
Replacing the outer bearing ring of the transfer case cover A
Replacing the outer ring of the transfer case bearing
Transfer case assembly
Automatic transmission assembly