HR-V 1 (1998-2006, petrol)

Control shaft assembly — removal and installation (Honda HR-V 1)

0

1. Loosen the bolt and remove the lock washer, then remove the roller.

2: Remove the control lever from the shaft.

3. Remove the control shaft assembly.

4. Install the control shaft assembly into the gearbox housing.

5. Install the control lever onto the control shaft.

6. Screw in and tighten the bolt, installing a new lock washer.

1. CONTROL SHAFT ASSEMBLY

1. CONTROL SHAFT ASSEMBLY
2. GEARBOX CASE
3. CONTROL LEVER
4. LOCK WASHER. Replace
5. 6x1.0 mm, 14 Nm (1.4 kgf/m)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Automatic gearbox

Next ▶

Ring gear bearing — replacement
Flywheel housing bearings — replacement
Gearbox housing bearings — replacement
Flywheel housing input shaft seal — replacement
Differential — checking and replacing elements

Transfer case — design description
Replacing the transfer case drive gear bearing
Replacing the Transfer Case Driven Gear Bearing
Replacing the roller bearing of the transfer case housing
Replacing the outer bearing ring of the transfer case cover A

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This website uses cookies to ensure proper functioning. By clicking "OK," you agree.