Electric valves B and C of gear shifting — replacement (Honda Avancier 1)

Attention:

If you replace solenoid valves B and C at the same time, remember their installation locations.

The connector for solenoid valve B is black, and for solenoid valve C it is brown.

1. Unscrew the bolt (6 x 1.0 mm) and remove the solenoid valve B or C.

2. Install new O-rings, then install the solenoid valve.

Caution: Avoid exposure to foreign particles.

3. Make sure there is no rust, oil, dirt, etc. inside the connector. Install the connector securely.

[The original is located on the website: HondaBook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Automatic gearbox

Next ▶

Shift Solenoid Valves B and C — Check
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assembly —…
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assy — Check
Electrical fault diagnostics — diagnostic description
Component arrangement

Automatic transmission clutch pressure solenoid valves A and B — checking
Electric valves A and B of pressure in the automatic transmission clutch —…
Intermediate and secondary shaft speed sensors — replacement
Pressure switches in 2nd and 3rd gear clutches — replacement
Switch D3 and Switch Low hold — replacement