HR-V 1 (1998-2006, petrol)

Testing the Parking Brake Switch (Honda HR-V 1)

0

1. Remove the rear console and disconnect the connector from the switch.

2. Check if there is continuity between the positive terminal and ground:

When the lever is tightened (at the top), there should be conductivity.
When the lever is released (at the bottom), there should be no conductivity.

1. below; 2. at the top; 3. lever; 4. mass; 5.…

1. below; 2. at the top; 3. lever; 4. mass; 5. positive terminal

[Original material on the website: HondaBook.ru]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Brake system

Next ▶

Brake system indicator wiring diagram
Bleeding the brake system
Parking brake — checking and adjusting
Brake pedal — check
Rubber parts of the brake system and brake booster

Testing the brake fluid level sensor
Front Brake Pads — Checking and Replacing
Front Brake Disc — Checking Runout
Checking the thickness and parallelism of the disc
Front Brake Caliper — Disassembly and Assembly

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This website uses cookies to ensure proper functioning. By clicking "OK," you agree.