1. Remove the ashtray. Remove center console.
2. Remove the coin box, air ducts and ashtray lighting bracket.
3. Remove the instrument panel switches to the left and right of the steering wheel.
4. Remove the car radio. Pay attention to the countersunk screws at the back and bottom.
5. Lower the steering wheel to the lowest position. Remove shield.
6. Disconnect the control cables from the heater.
7. Loosen the four screws and gently push the control panel forward.
8. Disconnect the wiring connectors and remove the heater controller.
9. If the fan switch or other individual components are to be replaced, the corresponding control knobs must be removed prior to disassembly.
For installation:
10. Reassemble the individual components if they have been dismantled.
11. Insert the panel and lay the cables to the heater body.
12. Connect the wiring connectors. Make sure the harness is out of the work area.
13. Connect the cables to the heater block. Screw 4 fixing screws to the control panel.
14. Install the shield. Make sure it is level and every mounting screw is in place.
15. Insert the car radio.
16. Install and connect the shield switches, air ducts and ashtray bracket. Install the coin box.
17. Install console and ashtray.