2. (Models with left-hand drive and manual transmission) Remove the gear shift knob.
3. Bend back the holder (B) and disconnect the connector (C).
4. Disconnect the clips (D) and then remove the trim (A) as shown in the figure above.
Trim for manual transmission lever or automatic transmission selector (Honda Fit 1)
1. Release the stoppers and lower the glove box down.
2. (Models with left-hand drive and manual transmission) Remove the gear shift knob.
3. Bend back the holder (B) and disconnect the connector (C).
4. Disconnect the clips (D) and then remove the trim (A) as shown in the figure above.
2. (Models with left-hand drive and manual transmission) Remove the gear shift knob.
3. Bend back the holder (B) and disconnect the connector (C).
4. Disconnect the clips (D) and then remove the trim (A) as shown in the figure above.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)