2. Mark and disconnect the heater hoses at the firewall. Be prepared to collect any spilled coolant from the hoses and joints.
3. Disconnect the control cable from the heater valve.
4. Remove the instrument panel.
5. Remove the vertical bracket.
6. Unscrew the 4 mounting bolts and remove the heater assembly.
7. Assembly is done in reverse order. Pay attention to the following points:
- a. Use grease on all O-rings.
- b. Check the position of the inlet and outlet hoses in relation to the heater to ensure that they are not reversed. Install the clamps in the correct positions and ensure that they are securely fastened.
- c. Fill and bleed the cooling system using the bleed bolt.
- d. Make sure all flaps opening/closing cables are securely connected for proper operation of the flaps.
[The original text of the article is located on the website www.HondaBook.ru]