2. Install the three set bolts and tighten them.
1. Fitting bolts, 10 x 1.25 mm, 39 Nm (4.0 kgf/m)
2. Intermediate shaft
3. Fill the transmission with the recommended MTF or ATF fluid.
(Information obtained from this source: «www.HondaBook.ru»)
Installing the intermediate shaft (Honda HR-V 1)
1. Thoroughly clean the areas where the intermediate shaft and gearbox (differential) meet with solvent or carburetor cleaner and dry with compressed air. Insert the intermediate shaft assembly into the differential. To avoid damaging the differential seal, hold the intermediate shaft horizontally.
2. Install the three set bolts and tighten them.
1. Fitting bolts, 10 x 1.25 mm, 39 Nm (4.0 kgf/m)
2. Intermediate shaft
3. Fill the transmission with the recommended MTF or ATF fluid.
(Information obtained from this source: «www.HondaBook.ru»)
2. Install the three set bolts and tighten them.
1. Fitting bolts, 10 x 1.25 mm, 39 Nm (4.0 kgf/m)
2. Intermediate shaft
3. Fill the transmission with the recommended MTF or ATF fluid.
(Information obtained from this source: «www.HondaBook.ru»)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits