Note:
- Clean disassembled parts thoroughly with solvent and dry with compressed air. Do not wash rubber parts in solvent.
- When assembling, do not damage the metal rings on the intermediate shaft.
1. intermediate shaft; 2. bearing support ring; 3. outer ring clamp; 4. Fitted bolts, 10x1.25 mm, 39 Nm (4.0 kgf/m); 5. Replace the retaining ring; 6. outer seal. replace. pack the outer seal with grease from the inside; 7. bearing support; 8. intermediate shaft bearing. replace; 9. Inner ring clamp; 10. intermediate shaft ring
The original is located on the website: www.hondabook.ru