Installing the rear drive shaft (Honda HR-V 1)

1. Place a new snap ring on the outer joint.

2. Using the special tool, install the rear drive shaft as shown in the figure.

3. Unscrew the two mounting bolts of the support disk.

4. Install the rear wheel hub bearing assembly.

5. Install the rear differential.

6. Fill the rear differential with oil.

7. Install the rear wheels and tighten the wheel nuts.

(Information obtained from this source HondaBook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Drive shafts and cardan

Next ▶

Rear Drive Shaft Assembly
Description of the design of the rear drive shafts
Disassembling the rear drive shaft
Removal the rear drive shaft
Installation of drive shafts

Removal the intermediate shaft
Installing the intermediate shaft
Disassembling the intermediate shaft
Description of the design of the intermediate shaft
Assembling the intermediate shaft

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet