Note: Be careful not to damage the metal rings on the intermediate shaft during assembly.
1. Remove the retaining ring.
2. Remove the intermediate shaft outer seal from the bearing support.
3. Remove the outer ring clamp.
1. BEARING SUPPORT
2. OUTER RING CLAMP
3. RETAINING RING. Replace
4. OUTER OIL SEAL. Replace
4. Using a special tool, press the intermediate shaft out of the shaft bearing as shown in the figure.
1. BEARING SUPPORT. Check for damage
2. Press out
3. INTERNAL CLAMP
4. AXLE SHAFT BASE, 07NAF-SR30101
5. INTERMEDIATE SHAFT. Check for damage
6. BEARING SUPPORT RING. Check for damage and deformation
5. Remove the inner ring clamp.
6. Using a special tool, press the intermediate shaft bearing out of the bearing support as shown in the figure.
1. BEARING
2. MARKET, 42x47 mm, 07746-0010300
3. Press out
4. MANDREL HANDLE, 07749-0010000
5. AXLE SHAFT BASE, 07NAF-SR30101
(Original published on this resource: HONDABOOK.ru)