2. Remove the center console (see chapter "Body").
3. Move the selector to the "N" position.
4. Unscrew the nut and disconnect the cable from the selector.
5. Remove the cable from the bracket by turning it as shown in the figure.
6. Push the transmission control cable (A) until it stops. Then pull the cable out 2 clicks (set to "N" position).
Note: Do not move the cable housing (B).
7. Turn on the ignition and make sure that the "N" position indicator of the automatic transmission selector is lit on the instrument cluster.
8. Turn off the ignition.
9. Install the pin (A) with a diameter of 6 mm into the holes (B) of the selector housing and the hole (C) of the selector lever.
10. Install the cable into the bracket as shown in the figure and connect the cable to the selector.
11. Make sure the cable is connected correctly.
12. Tighten the cable mounting nut.
- Tightening torque - 22 Nm
13. Remove the pin (A) installed to fix the selector position.
14. Turn on the ignition and, by moving the selector to each position, make sure that the indicator readings correspond to the selector position.
15. Check the correct operation of the selector and its lock.
16. Install the center console.