a) Pull out the parking brake lever, place chocks under the rear wheels and jack up the front of the vehicle.
b) Remove the front wheels.
a) Remove the brake pads.
d) Secure the brake disc by installing washers (A) and tightening the wheel nuts (B).
b) Install the dial indicator as shown in the figure.
c) Rotate the brake disc and measure the axial runout of the disc on the outer edge of the disc surface that contacts the brake pads.
- Maximum axial runout - 0.1 mm
If the disc runout is not within the norm, check the preload of the hub bearing and the bearing itself. If necessary, adjust the preload. If the bearing preload is within the norm, replace or regrind the brake disc.
2. Check the thickness and uniformity of wear of the brake disc.
a) Clean the surface of the brake disc that contacts the brake pads.
b) Using a micrometer, measure the thickness of the brake disc at a distance of approximately 10 mm from the edge of the disc every 45°.
Nominal thickness:
- left-hand drive models - 20.9 - 21.1 mm
right hand drive models:
- 2WD (except 1.5T) — 17 mm
- 2WD (1.5T configuration) and 4WD — 21 mm
Minimum allowable thickness:
- left hand drive models - 19 mm
right hand drive models:
- 2WD (except 1.5T) — 15 mm
- 2WD (1.5T configuration) and 4WD — 19 mm
c) Subtract the minimum measured value from the maximum.
- Maximum measurement difference is 0.015 mm
If the brake disc is worn unevenly (the difference in measurements exceeds the maximum permissible value), grind or replace the brake disc. If the thickness of the brake disc is less than the minimum permissible value, replace the brake disc.
3. Check the thickness of the brake shoe linings.
a) Jack up the front of the car and place it on stands.
b) Remove the front wheels.
c) Check the thickness of the brake shoe linings.
Standard thickness:
- 2WD (except for 1.5T) — 9.5 mm
- 2WD (1.5T configuration) and 4WD — 9.0 mm
Minimum thickness - 1.6 mm
Inner brake shoe.
Outer brake shoe.
d) Replace the brake pads as a set (right and left sides at the same time) if at least one of the pad linings has a minimum or lesser thickness.
[Original material on the website: www.hondabook.ru]