Note: Tightening torques are specified in the table "Tightening torques for brake pipes and hoses".
Replacement of brake pipes and hoses.
Tightening torques for brake pipes and hoses.
(The original is located on the website: «www.hondabook.ru»)
Brake hoses (Honda Fit 1)
Replace the brake pipes and hoses using the diagram "Replacing the brake pipes and hoses".
Replacement of brake pipes and hoses.
Tightening torques for brake pipes and hoses.
(The original is located on the website: «www.hondabook.ru»)
Replacement of brake pipes and hoses.
Tightening torques for brake pipes and hoses.
(The original is located on the website: «www.hondabook.ru»)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)