Note: On 4-cylinder models with manual transmission, a Nippondenso starter with a non-removable traction relay is used. If the latter fails, the entire assembly must be replaced. The description below applies to Mitsuba starters used on V6 models.
1. Disconnect the negative cable from the battery.
Warning! If the car stereo system is equipped with a security code, make sure you have the correct combination to activate the audio system before disconnecting the battery!
2. Remove the starter (see Section Removal and installation the starter).
3. Disconnect the large wire connecting the solenoid relay to the starter motor terminal.
4. Remove the long bolts securing the end cover to the gearbox casing. Remove the anchor assembly housing.
5. Remove the mounting screws and separate the gearbox casing from the front cover of the assembly.
6. Remove the mounting screws from the gearbox casing and remove the traction relay.
7. Installation is carried out in the reverse order. Before assembly, lubricate the drive lever and the plunger of the traction relay with assembly grease.
[You will find the original on the portal: www.hondabook.ru]