Prelude
1. Make sure the ignition is off (OFF).
2. Remove the cover from the front of the console. The console does not require removal.
3. Remove the 4 control box mounting bolts.
Once the mounting bolts are removed, the stored error codes are lost.
4. Carefully disconnect the wiring harnesses.
For installation:
5. Attach wiring harnesses; put the control unit in place.
6. Tighten 4 bolts; tighten them 10 Nm.
7. Install the front cover on the console. Switch on the ignition and check the correct functioning of the AB5.
Accord
1. Make sure the ignition is off (OFF). Loosen the screws securing the control unit. Don't lose nuts. Loosen the bolt securing the ground.
Once the mounting bolts are removed, the stored error codes are lost.
2. Remove the control box and cover.
3. Carefully disconnect the connectors from the control box.
For installation:
4. Connect the connectors to the block.
5. Replace the cover; install the assembly and tighten the bolts tightly. Screw on the bolt holding grounding.
6. Turn on the ignition and check the correct functioning of the ABS.