Warning: Make sure the jacks and safety stands are securely installed (see chapter 1).
1. Raise the front of the vehicle and secure it on safety stands (see chapter 1).
2. Apply the parking brake and securely block both rear wheels.
3. Drain the MTF transmission fluid (see above).
4. Remove the exhaust pipe A.
1. GASKET. Replace 3
2. GASKET. Replace
3. SELF-LOCKING NUT. Replace
4. EXHAUST PIPE A
5. SELF-LOCKING NUT. Replace
5. Mark the flanges of the propeller shaft and transfer case assembly.
6. Separate the propeller shaft from the transfer case assembly.
1. TAGS
2. 8 x 1.25 mm. Replace
3. CARDAN SHAFT
7. Remove the rear stiffener, then remove the transfer case assembly.
Note: When servicing the transfer case assembly, do not allow dust or foreign objects to enter the gearbox.
1. REAR STIFFENER
2. TRANSFER CASE ASSEMBLY
3. O-RING. Replace
4. REFERENCE PIN
The original is located on the website HondaBook