1. WASHER, Replace
2. REVERSE LIGHT SWITCH, 25 Nm (2.5 kgf/m)
2. Check the conductivity between the terminals. There should be continuity when the lever is switched to the reverse position.
3. Replace the switch if necessary.
Reverse light switch (Honda HR-V 1)
1. Disconnect the 2-pin connector of the reverse light switch.
1. WASHER, Replace
2. REVERSE LIGHT SWITCH, 25 Nm (2.5 kgf/m)
2. Check the conductivity between the terminals. There should be continuity when the lever is switched to the reverse position.
3. Replace the switch if necessary.
1. WASHER, Replace
2. REVERSE LIGHT SWITCH, 25 Nm (2.5 kgf/m)
2. Check the conductivity between the terminals. There should be continuity when the lever is switched to the reverse position.
3. Replace the switch if necessary.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits