Note: When installing the rear differential and mount assemblies, first tighten the rear differential mount B mounting bolts (A), then the rear differential rubber mount A mounting bolts (B).
1. REAR DIFFERENTIAL SUPPORT
2. 12x1.25 mm, 59 Nm (6.0 kgf/m)
3. REAR DIFFERENTIAL
4. WASHER
5. 12x1.25 mm, 59 Nm (6.0 kgf/m)
6. (B) 10x1.25 mm, 44 Nm (4.5 kgf/m)
7. REAR DIFFERENTIAL RUBBER MOUNT A
8. REAR DIFFERENTIAL SUPPORT BRACKET A
9. 12x1.25 mm, 59 Nm (6.0 kgf/m)
10. (A) 10x1.25 mm, 49 Nm (5.0 kgf/m)
11. PLATE
1. Place the rear differential on a jack and raise it to the required height for assembly.
2. Thoroughly clean the drive shaft/differential interface areas with solvent or carburetor cleaner and dry with compressed air. Insert the inner end of the drive shaft into the differential until the snap ring engages in the groove.
3. Tighten the two rear differential support B mounting bolts.
4. Tighten the four rear differential support A mounting bolts.
5. Connect the breather tube to the rear differential.
6. Secure the ball joint of the stabilizer link with a hex key and tighten the flange nut.
7. Attach the driveshaft to the rear differential, aligning the marks.
8. Fill the rear differential with oil (see above).