Crankshaft oil seal — installation (Honda HR-V 1)

The surface under the oil seal on the cylinder block must be dry. Apply a thin layer of oil to the crankshaft and to the edge of the oil seal.

1. Press the crankshaft oil seal into the right cover.

Note: Press in the crankshaft oil seal without tilting it.

1. MANDREL HANDLE, 0P49-0010000
2. Install the oil seal with the number side facing out.
3. MARKET, 96 mm, 07948-SB00101
4. RIGHT COVER

2. Using a feeler gauge, make sure the gap is the same around the entire circumference. Gap size: 0.5-0.8 mm

1. RIGHT COVER
2. CRANKSHAFT SEAL
3. RIGHT COVER
4. 0.5-0.8 mm

Note: For installation of the crankshaft oil seal on the oil pump side, see below.

[Full version on the source website «HondaBook.ru»]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Engine repair

Next ▶

Piston rings — checking and replacing
Piston pins — installation and inspection
Connecting rods — selection
Piston pins — removal
Cylinder Block — Checking and Honing

Pistons — installation
Crankshaft — installation
Oil pan — installation
Cylinder Head and Valve Train Specifications
Cylinder Block Specifications

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet