Steering wheel — installation (Honda HR-V 1)

1. Before installation, make sure the front wheels are in the straight-ahead position, then center the spiral wire. To do this, first turn the spiral wire clockwise until it stops. Then turn it counterclockwise about two and a half turns. The arrow on the spiral wire label should point straight up.

2. Position the two tabs of the turn signal canceling sleeve as shown in the figure, and install the steering wheel onto the steering gear shaft, making sure that the steering wheel shaft fits into the pins of the spiral wire and the tabs of the turn signal canceling sleeve. When installing the steering wheel, do not knock the steering wheel or the steering gear shaft.

1. spiral wire; 2. arrow

3. Tighten the steering wheel nut to a torque of 49 Nm (5.0 kgf/m).

4. Connect the horn connector and the mode switch connector.

5. Install the driver's airbag assembly and ensure that the system operates properly.

6. Check the operation of the horn, mode switch and turn signal switch.