(Models with left-hand drive and automatic transmission)
Install the intermediate drive shaft (A).
Note: When installing, hold the intermediate drive shaft in a horizontal position so that the sharp splines of the shaft do not damage the seal (B) of the gearbox output shaft.
2. Tighten the bolts (A).
3. Install the cover and tighten the mounting bolts.
- Tightening torque - 12 Nm
4. Install the right drive shaft (see section "Front drive shafts").
5. Fill the automatic transmission with working fluid (see chapter "Maintenance and general check and adjustment procedures").
(Models are pitted against steering wheel and 4WD)
1. Install the intermediate drive shaft (A).
Note: When removing, hold the intermediate drive shaft in a horizontal position so that the sharp splines on the shaft do not damage the gearbox output shaft seal.
2. Tighten the bolts (A and B).
- Tightening torque - 39 Nm
3. Install the right drive shaft (see section "Front drive shafts").
4. Fill the automatic transmission (variator) with working fluid (see chapter "Maintenance and general check and adjustment procedures").