Checking the cylinder head for flatness (Honda Fit 1)

Using a precision ruler and feeler gauge, check the cylinder head for flatness in the areas shown in the figure.

• Nominal flatness - 0.07 mm
• Maximum flatness - 0.08 mm

If the flatness is within 0.08 - 0.20 mm, grind the cylinder head. The maximum warpage at which regrinding is possible is 0.2 mm at a cylinder head height of 120 mm.

• Nominal height of cylinder head - 119.9 - 120.1 mm

The article is based on information from the website www.hondabook.ru