Removal and installation the rear wheel hub (2WD models with rear drum brakes).
1 - rear suspension beam,
2 - trunnion,
3 - brake mechanism,
4 - hub,
5 - nut,
6 - cap,
7 - brake drum.
Removal and installation
1. Jack up the rear of the vehicle and place it on stands.
2. Unscrew the nuts and remove the wheel,
3. Remove the cap (A).
4. Unlock the rim (C) of the nut (B) and unscrew the nut.
- Tightening torque - 181 Nm
5. Unscrew the two screws securing the brake drum.
6. Tighten two suitable bolts as shown in the figure to remove the brake drum.
7. Remove the brake drum and hub (A).
8. Installation is carried out in the reverse order of removal.
When installing:
- use new nuts and cap;
- lock the hub mounting nut;
- check and, if necessary, adjust the rear wheel alignment angles;
- check and, if necessary, adjust the travel of the parking brake lever.
(The article is based on information from the website HondaBook.ru)