Rear Suspension Knuckle and Hub (4WD Models) — Wheel Bearing Replacement (Honda Avancier 1)

1. Remove the rear wheel hub.



2. Remove the inner ring.



3. Remove the parking brake assembly from the support disc (see chapter Brake system).

4. Unscrew the nut (16 mm) and two nuts (10 mm) securing the support disk from the knuckle (see chapter Brake system).

5. Remove the support disk and retaining ring from the knuckle.



6. Press the wheel bearing out of the knuckle.





7. Press the wheel bearing into the knuckle.



8. Install the retaining ring and support disc (see chapter Brake system).



9. Press in the rear wheel hub.



10. Complete the installation in the reverse order of removal.

11. Check and adjust the wheel alignment angles (see above).