Removal and installation
Removal and installation the rear wheel hub (2WD models with rear disc brakes).
1 - rear suspension beam,
2 - trunnion,
3 - mudguard,
4 - hub,
5 - nut,
6 - cap,
7 - brake disc.
1. Jack up the rear of the vehicle and place it on stands.
2. Loosen the nuts and remove the rear wheels.
3. Loosen the bolts, remove the brake caliper and hang it aside.
4. Using a screwdriver, remove the cap (A).
5. Unlock the nut rim (C) and unscrew the nut (B).
6. Loosen the screws (A).
7. Tighten two suitable bolts as shown in the figure to remove the brake disc (B).
8. Remove the hub.
9. Installation is carried out in the reverse order of removal.
When installing:
- use new nuts and cap;
- lock the hub mounting nut;
- check and, if necessary, adjust the rear wheel alignment angles;
- check and, if necessary, adjust the travel of the parking brake lever.
The text of the article is available on the website HONDABOOK