Contents: Front doors ⇊ Rear doors ⇊
Caution: Wear gloves to protect your hands from cuts when performing procedures through access holes in the door frame.
Front doors
1. Remove the door interior trim panel and moisture protection shield (see Section Removal and installation interior door trim panels).
2. Remove the window glass (see Section Removal and installation of door glass).
3. On models equipped with power windows, disconnect the window regulator drive motor wiring connector.
4. Remove the bolts securing the door window regulator/drive motor assembly.
 |
 |
5. On Coupe models, scissor-type regulators are used. Before unscrewing the mounting bolts, mark the position of the rear upper roller guide bolt. Unscrew the upper and rear roller guide bolts, then loosen the four motor mounting bolts (on manual models - window handles).
6. Remove the equalizer lever and regulator assemblies through the specially provided hole in the door frame.
7. Installation is carried out in the reverse order. Do not forget to lubricate the guide rollers and the friction surfaces of the regulator.
Rear doors
1. Remove the door interior trim panel and moisture protection shield (see Section Removal and installation interior door trim panels).
2. Remove the window glass (see Section Removal and installation of door glass).
3. On models equipped with power windows, disconnect the window regulator drive motor wiring connector.
4. Remove the bolts securing the door window regulator/drive motor assembly.
5. Remove the equalizer lever and regulator assemblies through the specially provided hole in the door frame.
6. Installation is carried out in the reverse order. Do not forget to lubricate the guide rollers and the friction surfaces of the regulator.
(Material obtained from the website www.hondabook.ru)