Installing pistons (Honda Fit 1)

1. Install a special tool to compress the compression rings.

2. Make sure all inserts are in place.

3. Make sure that the arrows on the piston crowns point towards the front of the engine (towards the timing drive).

4. Using the wooden handle of a hammer, install the pistons into the cylinder block.

5. Set all pistons to TDC.

The article was taken from the website: hondabook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Engine repair

Next ▶

Checking the connecting rod bolts
Checking and replacing piston rings
Disassembly, inspection and replacement of connecting rod and piston group…
Cylinder honing
Checking the cylinder block and pistons

Installing the crankshaft
Installing the oil pan
Intake manifold
Exhaust manifold
Exhaust pipe and muffler