2. Remove the rear wheels.
3. Release the parking brake lever and remove the brake drum.
4. Press the spring clip (B) and turn the pin (A). Remove the spring clip.
5. Remove the lower return spring (A) and brake shoes assembly.
6. Remove the front brake shoe (B) with the upper return spring (C). Remove the springs and levers from the front shoe.
7. Disconnect the parking brake cable from the parking brake lever (E). Remove the rear brake shoe (D) with the parking brake lever.
8. Remove the retainer (A), washer (B) and pin (C), then disconnect the parking brake actuator lever (D) from the rear brake shoe (E).
9. Replace the brake pads.
10. Install the parking brake actuator lever (B) onto the brake shoe (C), install the pin (A) and washer (D). Install the new retainer (E) and tighten it with pliers.
11. Connect the parking brake cable to the parking brake lever.
12. Apply special brake lubricant to the surfaces shown in the figure.
13. Apply special brake lubricant to the areas shown in the figure.
Attention:
- Remove excess grease;
- Avoid getting grease on the brake pads.
moving parts;
trailing edge of the brake shoe.
14. Install the adjusting levers "A" and "B" onto the adjusting bolt (C).
15. Install the upper return spring (D) and adjuster assembly. Install the adjuster lever (E) and adjuster spring (F) onto the front brake shoe (G).
16. Install the spring clip (B) onto the pin (A). Press the clips and turn the pin.
17. Install the lower return spring.
18. Install the brake drum and wheel.
19. Bleed the brake system (see section "Bleeding the brake system").
20. Press the brake pedal several times.
21. Check and, if necessary, adjust the travel of the parking brake lever.
(Original published on this resource «HONDABOOK»)