Working brake cylinder:
1 - anther,
2 - piston cuff,
3 - bleed nipple,
4 - bleed nipple cap,
5 - piston cuff,
6 - piston,
7 - anther,
8 - cylinder body,
9 - spring,
10 - piston assembly.
Disassembly and assembly of the working brake cylinder (Honda Fit 1)
Removal and installation of parts should be carried out using the assembly drawing "Working brake cylinder".
Working brake cylinder:
1 - anther,
2 - piston cuff,
3 - bleed nipple,
4 - bleed nipple cap,
5 - piston cuff,
6 - piston,
7 - anther,
8 - cylinder body,
9 - spring,
10 - piston assembly.
Working brake cylinder:
1 - anther,
2 - piston cuff,
3 - bleed nipple,
4 - bleed nipple cap,
5 - piston cuff,
6 - piston,
7 - anther,
8 - cylinder body,
9 - spring,
10 - piston assembly.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)