Models for Europe, Australia and South Africa
1. OIL PUMP. Repair (see below). Examination (see below). Apply sealant to the contact surface of the block.
2. REFERENCE PIN
3. O-RING, Replace.
4. OIL PRESSURE SENSOR, 18 Nm (1.8 kgf/m). 1/8 inch BSPT (British Pipe Tapered Thread) 28 threads/inch. Use appropriate sealant.
5. O-RING. Replace.
6. OIL BREATHER CHAMBER
7. 6x1.0 mm, 11 Nm (1.1 kgf/m)
8. OIL FILTER. Replacement (see below)
9. REFLECTOR PLATE
10. OIL PAN GASKET. Replace.
11. OIL PAN.
12. WASHER, Replace.
13. DRAIN HOLE BOLT, 39 Nm (4.0 kgf/m). Do not overtighten.
14. 6x1.0 mm, 12 Nm (1.2 kgf/m) 15.6x1.0 mm, 11 Nm (1.1 kgf/m)
16. MESH OIL FILTER
17. 6x1.0 mm, 11 Nm (1.1 kgf/m)
18. GASKET. Replace.
19. 6x1.0 mm, 11 Nm (1.1 kgf/m)
Note:
- When assembling, install new O-rings.
- Apply oil to the O-rings before installation.
- Use sealant P/N 08C70-K0234M, 08C70-K0334M or 08C70-X0331S.
- Before installation, clean the contact surfaces under the oil pan gasket.
Except for models for Europe, Australia and South Africa
1. OIL PUMP. Repair (see below). Examination (see below). Apply sealant to the contact surface of the block.
2. REFERENCE PIN
3. O-RING. Replace.
4. OIL PRESSURE SENSOR, 18 Nm(1.8 kgf/m). 1/8 inch BSPT (British Pipe Tapered Thread) 28 threads/inch. Use appropriate sealant.
5. O-RING. Replace.
6. OIL BREATHER CHAMBER
7. 6x1.0 mm, 11 Nm (1.1 kgf/m)
8. OIL FILTER. Replacement (see below)
9. Apply sealant at these points.
10. OIL PAN GASKET. Replace.
11. OIL PAN.
12. 6x1.0 mm, 12 Nm (1.2 kgf/m)
13. DRAIN HOLE BOLT, 44 Nm (4.5 kgf/m). Do not overtighten.
14. WASHER, Replace.
15. Apply sealant at these points.
16. 6x1.0 mm, 11 Nm (1.1 kgf/m)
17. 6x1.0 mm, 11 Nm (1.1 kgf/m)
18. GASKET. Replace. 19.6x1.0 mm, 11 Nm (1.1 kgf/m)
(The text can be found on the website: «HondaBook»)