2. Disconnect the 5-pin connector, then remove the mounting screws from the switch.
3. Check the presence of conductivity between the contacts in all switch positions in accordance with the table.
(Full text available on the portal: HONDABOOK)
Testing the passenger power window switch (Honda HR-V 1)
1. Remove the pocket from the armrest.
2. Disconnect the 5-pin connector, then remove the mounting screws from the switch.
3. Check the presence of conductivity between the contacts in all switch positions in accordance with the table.
(Full text available on the portal: HONDABOOK)
2. Disconnect the 5-pin connector, then remove the mounting screws from the switch.
3. Check the presence of conductivity between the contacts in all switch positions in accordance with the table.
(Full text available on the portal: HONDABOOK)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits