2. Install the spring compressor. Compress the spring and remove the crackers.
3. Remove the valves, valve springs, spring seats.
(You will find the original on the portal: hondabook.ru)
Disassembling the cylinder head (Honda Fit 1)
1. Using a suitable socket head and a plastic-faced hammer, lightly tap the spring plate to loosen the crackers.
2. Install the spring compressor. Compress the spring and remove the crackers.
3. Remove the valves, valve springs, spring seats.
(You will find the original on the portal: hondabook.ru)
2. Install the spring compressor. Compress the spring and remove the crackers.
3. Remove the valves, valve springs, spring seats.
(You will find the original on the portal: hondabook.ru)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)