2. Rotate the pulley by hand to make sure it rotates without difficulty or extraneous noise.
3. Measure the clearance between the pressure plate and the pulley using a special set of rulers. Make sure that the clearance does not change around the entire circumference of the pulley.
- Nominal clearance: 0.35 - 0.65 mm.
4. Check the continuity between the thermal fuse terminals.
Right hand drive models.
Left-hand drive models.
If there is no conductivity, the thermal fuse should be replaced.
5. Disconnect the clutch winding terminal and measure the resistance between the terminal and the clutch body as shown in the figure.
Right hand drive models.
Left-hand drive models.
Make sure that the resistance at 20°C corresponds to the nominal value.
Nominal resistance:
- right-hand drive models: 3.05-3.35 Ohm.
- left-hand drive models - 3.15-3.45 Ohm.
If the voltage does not correspond to the nominal value, the coupling winding should be replaced.