Caution: Before installation, make sure that there is no dirt on the rubbing surfaces and splines.
1. Install the ring clamp onto the inner joint.
2. Insert the outer joint into the rear wheel hub.
Insert strictly in the lateral direction, otherwise the ABS wheel sensor may be damaged.
3. Insert the rear drive shafts into the rear differential and install it on the frame (see section "Rear differential"),
4. Tighten the hub nut.
5. Coal the nut onto the shaft groove.
6. Install the rear wheels.
Make sure that there are no foreign particles on the contact surfaces of the wheels and brake discs.
