2. Place marks on the #2 driveshaft and the rear differential where they connect.
3. Remove the four 12-point bolts and separate the #2 driveshaft from the rear differential.
4. Unscrew the self-locking bolt (10 mm) holding the central bearing support.
5. Apply marks to the cardan shaft No.1 and the transfer case at the point where they are connected.
6. Remove the 4 12-point bolts and separate the #1 driveshaft from the transfer case.
7. Install in the reverse order of removal.
Perform installation according to the marks.
Full version on the source website hondabook.ru