Attention.
- Wash all components except rubber with flushing oil and blow with an air gun.
- Do not damage the metal rings on the intermediate shaft while performing work.
- When installing the outer seal, make sure that the edges do not curl.
1. Press the intermediate shaft bearing into the support.
2. Install the inner snap ring into the bearing support.
Point the beveled side outward.
3. Press the intermediate shaft into the bearing.
4. Install the outer snap ring onto the intermediate shaft.
Point the beveled side outward.
5. Install the intermediate shaft outer oil seal.
6. Install the ring clamp onto the intermediate shaft.
Material obtained from the website hondabook.ru