See the table of fault codes in Chapter. Engine management system.
Before performing this work, see the corresponding section in Chapter. Engine management system.
*The test to reproduce the malfunction while driving is performed at engine speeds above 6000/min with the selector lever in position D for 2 sec. The test is performed 2 or more times.
Attention:
If work is performed indoors, follow these requirements:
- If the check is performed with the front wheels raised, be sure to use rigid supports and support the rear wheels with chocks.
- Remove exhaust gases using a pipe and ventilate the room thoroughly.
Do not exceed critical engine speed.
* Oil pressure is measured at 3 engine speed values: 1000/min, 2000/min and 4000/min.
Since the test is performed under no-load conditions, perform the work for a short time (less than 1 min.)
