Note: Separating the pulley, drive shaft side housing and rotor is only necessary when replacing the front bearing. Loosen the pulley with tools as shown in the figure. Use an impact wrench if necessary.
1. rear bearing; 2. rotor; 3. bearing insulator; 4. front bearing; 5. 22mm socket wrench; 6. pulley; 7. 10mm socket wrench; 8. pulley lock nut, 111 Nm (11.3 kgf/m); 9. pulley; 10. pulley lock nut, 111 Nm (11.3 kgf/m); 11. rear housing; 12. insulating sleeve; 13. terminal insulator; 14. end cap; 15. Rectifier assembly; 16. voltage regulator; 17. stator through bolt; 18. brush assembly; 19. brush holder insulator; 20. Caution: Do not allow grease or oil to come into contact with the slip rings; 21. spacer ring