Note: Remove the pulley only when replacing the front bearing. Loosen the pulley lock nut with a 10mm and 22mm socket wrench. Use an impact wrench if necessary.
1. Caution: Do not allow grease or oil to come into contact with the slip rings.; 2. rotor; 3. aluminum plates; 4. 24mm socket wrench; 5. pulley lock nut, 111 Nm (11.3 kgf/m); 6. pulley; 7. housing from the drive shaft side; 8. through bolt; 9. pulley; 10. pulley lock nut, 111 Nm (11.3 kgf/m); 11. stator; 12. brush; 13. rear body; 14. terminal; 15. voltage regulator; 16. Rectifier assembly; 17. front bearing; 18. bearing insulator; 19. spacer ring; 20. rear bearing
The article is based on information from the website: hondabook.ru