Contents: Replacement ⇊ Adjustment ⇊
Replacement
Warning!
- Headlights with halogen lamps become very hot during operation; do not touch them or their mounting hardware immediately after they have been disconnected.
- Do not attempt to replace or clean headlights while the bulbs are on.
1. Remove the front bumper (see chap. "Body").
2. Disconnect the connectors from the headlights.
3. Remove the two mounting bolts from the corner top beam.
4. Remove the four mounting bolts, then remove the headlight assembly.
5. After replacement, adjust the headlights according to local requirements.
Adjustment
Before adjusting the headlights:
- Park the car on a level surface.
- Make sure the fuel tank is full.
- The driver's seat must be occupied by the driver or a person of similar weight.
- Place the standard load in the trunk.
- Press down on the front and rear bumpers several times to ensure the vehicle is properly seated.
1. Open the hood.
2. Adjust the headlight beam according to local requirements by rotating the regulators.
Note: Since the outer lenses are made of polymer material, do not cover the headlights when they are on.
(The text can be found on the website HondaBook)