Contents: Rear door pillars ⇊ Rear door interior trim ⇊ External door trim ⇊ Door spoiler (some left hand drive…⇊ Rear door lock ⇊ Door seal ⇊
Note: Assembly is carried out in the reverse order of disassembly.
Rear door pillars
1. Loosen the bolts (A) and disconnect the pillar (C) from the body.
2. Remove the bolts (B) and detach the pillar from the rear door.
Rear door interior trim
1. Using a screwdriver, disconnect the clips (A) and remove the inner door handle (D) (see the illustration "Removing the rear door interior trim").
Note: Please wrap the screwdriver with protective tape before use.
2. Disconnect the rear door lock fastening clips (B).
3. Disconnect the clips (C) and remove the interior trim (E).
External door trim
1. Remove the door interior trim and rear door window wiper motor.
2. From the inside of the door, unscrew the bolt (A) and disconnect the fasteners (B and C).
- Tightening torque - 9.8 Nm
3. Disconnect the clip (B) and remove the door outer trim (A).
Door spoiler (some left hand drive models)
Remove the covers (B).
2. Loosen the bolts (C).
- Tightening torque - 9.8 Nm
3. Lift the spoiler (A) and remove it.
Rear door lock
(Except for left-hand drive model without rear door lock cylinder)
1. Remove the interior door trim.
2. Disconnect the rear door lock (D) drive cable (A) from the outside handle.
3. Disconnect the connectors of the lock (B) and the electric drive (C) of the rear door lock.
4. Disconnect the rod (A) of the lock cylinder (B).
5. Loosen the bolts, pull the lock towards you and remove it.
- Tightening torque - 9.8 Nm
6. Loosen the bolts and remove the lock cylinder (A) as shown in the figure.
- Tightening torque - 9.8 Nm
(Left hand drive models without rear door lock cylinder)
1. Remove the interior door trim.
2. Disconnect the rear door lock (D) drive cable (A) from the outside handle.
3. Disconnect the connectors of the lock (B) and the electric drive (C) of the rear door lock.
4. Loosen the bolts, pull the lock towards you and remove it.
- Tightening torque - 9.8 Nm
Door seal
1. Remove the door seal (A).
2. Clean and degrease the contact surface of the seal,
3. Place a timing mark (B) on the seal. Align the mark with the pin as shown in the figure and install the seal.
4. Check the tightness of the seal.