Turn off the ignition.
Measure the voltage between Yellow/Blue (+) 22 and Black (-) 32 pins.
If there is battery voltage, then the Bat power source is normal.
If there is no voltage, then you should check fuse No.1 (10 A) in the relay box under the hood.
If the fuse is normal, then you should repair the break in the Yellow/Blue wire between fuse #1 and terminal 22 of the control unit.
If the fuse is blown, it should be replaced.
(The text can be found on the website www.HondaBook.ru)
Checking the power supply (Bat) (Honda Accord 3)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Yaroslav Shiryaev
Checking the power supply (IG1) and ground
Checking the functionality of the EFE system control module
Checking the functionality of the EFE (Electro Fuel Evaporator) system
Checking the functionality of the air leak solenoid valve
Checking the functionality of the control electromagnetic valve of the…
Checking the functionality of the EFE system control module
Checking the functionality of the EFE (Electro Fuel Evaporator) system
Checking the functionality of the air leak solenoid valve
Checking the functionality of the control electromagnetic valve of the…
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Introduction to the guide
- User manual
- Maintenance
- Power unit
- Four-cylinder engines
- Six-cylinder engines
- Engine overhaul
- Cooling system
- Heater and air conditioner
- Power and exhaust systems
- Engine electrical equipment
- Engine management
- Transmission
- Mechanical gearbox
- Automatic gearbox
- Clutch and drive shafts
- Chassis and running gear
- Brake system
- Car suspension
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Maintenance
- Power unit
- Engine adjustment
- Engine repair
- Engine electrics
- Emission management
- Engine management (carburetor)
- Electronic injection
- Programmable injection
- Schematic of emission system
- Fuel system
- Feedback management
- Transmission
- Manual gearbox
- Automatic gearbox
- Clutch
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Ventilation and heating
- Air conditioner
- Cruise control system
- Equipment and devices