Checking the power transistor (air conditioner with automatic control) (Honda Fit 1)

1. Remove the lower instrument panel trim on the passenger side.

2. Disconnect the power transistor connector.

3. Check the resistance between terminals "3" and "4" of the power transistor.

Nominal resistance - 1.5 kOhm ±1%

4. Disconnect the terminal (A) of the power transistor connector.

5. Connect the positive battery terminal to terminal (B) and the negative battery terminal to terminal (C).

6. Turn the ignition switch to "ON" and make sure the heater fan starts working.

(The original can be found on the resource: «www.hondabook.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Heater and air conditioner

Next ▶

Checking the air flow direction flap actuator (air conditioning with automatic…
Removal and installation the air flow direction flap actuator (air conditioning…
Checking the air flow mixing flap drive (air conditioning with automatic…
Removal and installation the air flow mixing flap drive (air conditioning with…
Checking the Sunlight Sensor (Automatic Air Conditioner)