Front suspension — device (Honda Avancier 1)

Examination

Attention.

Before assembly, clean the contact surfaces of the wheel and brake disc, as well as the contact surfaces of the brake disc and hub.

Remove the center caps from the inside of the wheel after removing the wheel.

[The article was taken from the website «HondaBook»]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Car suspension

Next ▶

Checking Wheels/Hubs — Removing Ball Joints
Checking wheels/hubs — wheel runout
Checking wheels/hubs — bearing axial play
Wheel alignment — procedure for adjusting wheel alignment angles
Wheel alignment angles — preliminary remarks

Front Suspension Steering Knuckle and Hub — Removal and Installation
Front Suspension Steering Knuckle and Hub — Wheel Bearing Replacement
Replacing the front suspension ball joint boot
Removal and installation the front suspension stabilizer
Front shock absorber

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet