Attention.
- Clean all components thoroughly before assembly.
- Pay attention to the direction of installation of the oil seals. The side of the oil seal with the groove should be directed towards the oil
- cameras.
- During assembly, be sure to replace components that are not reused with new ones.
- Do not flush seals and O-rings with flushing oil.
- To ensure better sliding of parts during the initial period of work during assembly, apply Honda Ultra V or Ultra PSF-II power steering fluid to the indicated areas.
- Do not over-tighten the new O-rings.
- Do not stretch the polymer sealing rings more than necessary, and avoid uneven stretching in certain areas. In addition, after installation, compress the sealing ring using a rubber tube and a clamp.
(The original text of the article is located on the website www.hondabook.ru)