Clearance check
1. Measure the gap between the reverse shift fork holder and the 5th/reverse shift pin.
2. If the gaps exceed the specified limit, measure the width of the grooves in the reverse shift fork holder.
- Standard A: 7.05-7.25mm
- Standard B: 7.4-7.7 im
If the groove width is out of specification, replace the reverse shift fork holder with a new one.
If the width of the slots is within acceptable limits, replace the 5th gear/reverse shift pin with a new one.
3. Measure the clearance between the reverse idle gear and the reverse shift fork holder.
- Standard: 0.5-1.1mm
4. If the clearance exceeds the specified limits, measure the width of the reverse shift fork holder.
If the width is out of range, replace the reverse shift fork holder with a new one.
If the width is within tolerance, replace the reverse idler gear with a new one.