2. Measure the length of the brushes with a caliper.
Generator brush length:
- Standard (new): 10.5 mm
- Wear limit: 1.5 mm
3. If the length of the brushes is less than the permissible limit, replace the generator brushes as an assembly.
Checking the Generator Brushes (Denso) (Honda HR-V 1)
1. Remove the end cover, then take out the brush holder by unscrewing the two screws.
2. Measure the length of the brushes with a caliper.
Generator brush length:
3. If the length of the brushes is less than the permissible limit, replace the generator brushes as an assembly.
2. Measure the length of the brushes with a caliper.
Generator brush length:
3. If the length of the brushes is less than the permissible limit, replace the generator brushes as an assembly.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Fuel injection and control
- Power and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Rear differential
- Drive shafts and cardan
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Lighting system
- Electrical circuits