Note: When replacing the door lock, wear protective gloves.
1. Raise the glass fully.
2. Remove the outer handle (see above).
3. If necessary, remove the glass guide channel from the center lower guide. Loosen the bolt, then remove the center lower guide by pulling it down.
4. Unscrew the bolt, then remove the rod protective cover.
5. Separate the rear lock rod from the bellcrank. Remove the inner handle rod, then disconnect the door lock electric drive connector.
6. Remove the screws, then remove the inner handle and traction crank.
7. Installation is carried out in the reverse order of removal, taking into account the following:
- Insert the electric drive connectors correctly and connect all rods.
- Make sure the door locks and unlocks properly.