Note: Avoid scratching the body and adjacent components.
1. Remove:
- Radiator grille (see above).
- Inner wing.
- Wing panel.
2. Disconnect the hood release cable from the hood latch (see below).
3. Using a clamp remover, remove the clamps from the body, then remove the hood release cable from the vehicle.
1. left hand drive; 2. Pass the hood release cable through the hole in the body.; 3. hood release cable; 4. hood release cable; 5. right hand drive
4. Installation is performed in the reverse order of removal. Replace damaged clamps.
Original article on the website: www.hondabook.ru